HumanTechnik CM-2.4 Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Quick setup guide
Your CM-2.4 is already set and ready to use.
Adjusting the settings will only be neccesary in
cases of transmission interferences and / or poor
sound quality. Should adjustments be neccesary,
please note the detailed descriptions from page
20 onwards.
Setup and use:
Charge the devices: Plug the USB charging cab-
les into the USB jacks of the devices and connect
these to regular USB ports (computer, laptop,
USB power supplies).
The red charging status LED on the respective
device is lit during recharge. The LED switches off
when the battery is fully loaded. The charging time
is approx. 2 hours.
Plug the microphone into the MIC-input of the
transmitter (symbol
on transmitter).
Plug the earphones, headpnones or the neck
loop into one of the audio outputs EAR1 or EAR2
of the receiver (symbol
on receiver).
If using the neck loop:
Put the neckloop around your neck and set your
hearing aid to "T" or "MT" in order to transmit
sound information directly to the T-coil in your
hearing aid.
Switch the devices on:
Push the ON/OFF switch into the upper position.
English 16

Publicité

Table des Matières
loading

Table des Matières