How To Pair The Midland Btx2 Pro To More Than Two Units - Midland BTX2 PRO Guide D'utilisation

Voice activation (VOX)
Simply say something, after some seconds the communication will be opened and will
remain active for the time you are talking. If there is no conversation the intercom will
be closed after 40 seconds. If needed you can close the intercom manually without
waiting 40 seconds (just press the middle button).
If needed, you can disable the VOX feature simply by pressing the Backward button
for 7 sec. A voice announcement will advise you when the VOX is disabled. To turn the
VOX on again, just press the same button and a voice announcement will advise you
that the VOX is now active. This setting is remembered also if you turn off the unit.
Attention: The Voice activation (VOX) can open the intercom communication only to the
unit that was paired with the Middle button. If you choose to use a different button (Forward
or Backward ), you will be able to active the intercom only manually.
Adjusting the volume
Your Midland BTX2 PRO uses AGC technology, which automatically adjusts the liste-
ning volume in relation to background noises.
However, it is also possible to manually adjust the volume by means of the "Volume +"
and "Volume -"buttons. The volume setting is indipendent for each audio source:
intercom, stereo music, phone call, FM radio.
Attention: volume can be adjusted only when an audio connection is active.
Set up of the AGC system
To adjust the sensitivity of the AGC system you can use the "BT UPDATER" Pc
Software or the smartphone "BT SET-APP" application. You can choose different set
up based on your motorbike type (naked, touring, sport) or if you are riding as a pas-
senger. You can disable the AGC system pressing "Volume +" and "Volume -" togheter
for 3 sec.

How to pair the Midland BTX2 PRO to more than two units

One Midland BTX2 PRO unit can be paired to maximum three other BT units, that
means four in total.
The Midland BTX2 PRO has three main buttons (Forward, Middle and Rear). It is up to
you which button use to pair and activate the "Intercom", you are totally free to choose
the button you like more.
6
Rider 1
Rider 3
Passenger
The same button you will use to pair the unit will be also used to open/close the inter-
com communication. For example you can pair your passenger to the Middle button
and other motorbikers to the Backward and Forward button. Everytime you open the
"Intercom" connection to one person, the previous connection will be closed.
The connection is not a "chain", when two persons are talking it is not possible to break
(interrupt) the communication by one of the other units.
Pair the Midland BTX2 PRO to another Midland BTX2 PRO unit
To pair the Midland BTX2 PRO to another Midland BTX2 PRO unit, you must first
enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on per-
manently.
3. Now press the Middle or the Backward or the Forward button for 3 seconds. The
Blue and Red lights will flash.
4. Do the same procedure on the other unit, when successfully paired, each unit will
have the Blue light on for one second and then go back to the setup mode (Red
light always on).
5. Now the pairing procedure is complete, you can go on pairing other units on diffe-
rent button or just exit the setup mode to start using the units:
6. Double click on the Middle button, the Red light will turn off and the Blue light will
start flashing.
You can use now your BTX2PRO.
Rider 2
www.midlandeurope.com