Beurer FM 250 Mode D'emploi page 7

Step 6: Switch off the device
• To switch off the EMS circulation stimulator, briefly press the 0 ON/OFF
button on the device or on the remote control.
6.2 Lower leg stimulation
If you want to stimulate your lower legs at the same time as your feet, proceed as follows:
Step 1: Moisten the cuffs
• Remove the two cuffs from the packaging. Moisten the two cuffs with
water or a water-based electrode gel. This provides better conduction
of the electricity. Do not use cream or lotion; only use water or a water-
based electrode gel.
Step 2: Connect the connection cables to the cuff
• Connect the connection cables to the press stud on the cuff as shown.
Ensure that the connection cable is firmly connected to the cuff.
Step 3: Connect the connection cables to the device
WARNING
• Ensure that the device is switched off.
• Insert the connection cables into the L and R connection sock ets on the
front of the device.
Step 4: Position the cuffs on your lower legs
• Place the cuffs on your lower legs as shown. The electrode should be
positioned on your calf and may reach as far as your shin, depending on
the circumference of your leg.
• Make sure that the cuffs are fastened tightly, but still feel comfortable.
Position the connection cables so that you can easily move your feet back
and forth on the foot areas of the device.
Step 5: Start lower leg stimulation
• To start lower leg stimulation, follow steps 1 to 6 from section "6.1 Foot
stimulation".
12
7. Cleaning, storage and disposal
Cleaning
WARNING
• Always unplug the power cord from the socket and disconnect it from the device before carrying
out any cleaning.
• Always remove the batteries before cleaning the EMS circulation stimulator.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Clean the electrode surfaces on the EMS circulation stimulator and the cuffs with a cloth or damp
sponge after each use. Do not use any solvent-based cleaning products.
• Leave the EMS circulation stimulator to dry at room temperature, away from heat and sunlight.
• Do not use the EMS circulation stimulator again until it is completely dry.
Storage
If you do not plan to use the EMS circulation stimulator for a long period of time, we recom mend that you
store it in the original packing in a dry environment, ensuring it is not weighed down by additional items. Store
the device away from children, and pets. Do not place any objects on top of the EMS circulation stimulator.
Remove the batteries from the EMS circulation stimulator and remote control. Make sure that the storage
conditions are met in the storage location.
Disposal
Observe the local regulations for material disposal. Dispose of the device in accordance with local regulations.
If you have any questions, please contact the local authorities responsible for waste disposal.
8. Troubleshooting
Problem Cause
The EMS circulation stimulator The batteries are depleted.
will not switch on.
The batteries are not inserted
correctly.
The EMS circula tion stimulator is
not plugged in.
The remote control is not The batteries are flat.
responding.
The batteries are not inserted
correctly.
The EMS circulation stimulator Your feet are too dry.
is switched on but I cannot feel
any electrostimulation.
The electrostimulation is too The set intensity level is too low.
weak.
Solution
Replace the batteries.
Ensure that the batteries are
inserted correctly. Observe the
plus (+) and minus (−) polarity
signs.
Connect the power adapter to
the EMS circulation stimulator
and a suitable socket.
Replace the batteries in the
remote control.
Ensure that the batteries are
inserted correctly. Observe the
plus (+) and minus (−) polarity
signs.
Moisten the bottom of your feet.
If necessary, increase the inten-
sity level.
Increase the intensity level.
13