ADE WC 1600 Mode D'emploi page 62

Procedure:
1. Place the base station and the outdoor sensor close to
each other.
2. Remove the battery compartment cover on the rear
side of the outdoor sensor.
3. For each outdoor sensor, set a unique channel using
the switches. The sensor delivered with the weather
station uses channel 1 by default; for the second sensor
you should thus choose channel 2.
4. Insert two batteries of the type indicated on the base.
Pay attention to the correct polarity (+/-).
5. Replace the battery compartment cover.
6. Using the
sensor (1, 2 or 3) in order to have its data displayed.
You can then set up the new outdoor sensor at its own
installation site.
62
button, select the corresponding outdoor
You can also press the button
repeatedly until a small circle with an
arrow is displayed above OUT. This is a
sign that the data from the outdoor
sensors will automatically be called up
and displayed in succession.
Weather Station with Wireless Outdoor Sensor WS 1600