Size & Width Functions - Brother P-touch 1950 Mode D'emploi

The character size can be adjusted using both the Size and Width functions. Since the charac-
ter size that can be used depends on the width of the tape, the following table shows the char-
acter sizes that can be used with each tape width.
The default size setting is AUTO and the default width setting is OFF. The currently selected
size setting is always shown by the indicator above the display.
With the AUTO size setting, the machine compares your text with the width of the installed
tape and automatically adjusts the characters to the largest possible size. However, seven other
point sizes are also available, and each can be printed with either of the two width settings.

With the AUTO setting selected and 1/2" (12-mm) or 3/4" (18-mm) wide tape installed,
text consisting of just one line of only uppercase letters (and no accented characters)
will be printed with a character size slightly larger than a similar sentence also contain-
ing lowercase letters (i.e., 29 points for 1/2" (12-mm) wide tape and 52 points for 3/4"
(18-mm) wide tape).
Size Setting
(in points)
6
9
12
18
24
36
42
SIZE & WIDTH FUNCTIONS
Tape Widths
1/4" (6 mm)
3/8" (9 mm)
1/2" (12 mm)
3/4" (18 mm)
Width Setting
Off
Sizes (in points)
6, 9, 12
6, 9, 12, 18
6, 9, 12, 18, 24
6, 9, 12, 18, 24, 36, 42
Width Setting
On
27