Brother P-touch 1950 Mode D'emploi page 41

To turn the Length function on or off:
1 While holding down c, press T once, and keep c held down to display the
current length of the label (the text and both margins). Then the display will show the cur-
rent label length setting (ON or OFF).
2 While still holding down c, continue pressing T until the desired label length set-
ting is displayed.

The Length indicator comes on when ON is selected.
3 Release c. If ON was selected, the current label length setting is displayed.
4 Press h or e to select the desired length or use the number keys to enter a length.

To change the units (inches or centimeters) used to display the label length, press
M until the desired units are displayed.
To change the length in 1" (1.0-cm) steps, hold down either h or e, and then
release the key when the desired setting is displayed.
5 Press r.
EXAMPLE
To select a label length of 5":
1
While holding down
L E N G T H
2
While still holding down
T
ing
c
3
Release
c
, press
5 . 3 i n c h
c
until ON is displayed.
.
T
once, and keep
L E N G T H
O F F
, continue press-
c
held down.
L E N G T H
O N
L E N G T H
4 . 0 i n c h
37