Door Alignment - Impecca RC-1590 Manuel De L'utilisateur

4� Install the refrigerator in a convenient location away from extreme heat and cold� Allow sufficient clearance between the
refrigerator and side wall so the door(s) will open without obstruction� Refrigerator is not designed for recessed installation�
5� The floor on which the refrigerator should be placed must be flat, hard, solid, and even� The refrigerator should not be placed on
any soft material such as foam, plastic, etc�
6� To level your refrigerator, use the two leveling legs located on the bottom front of your refrigerator� Adjust by turning the legs
counter clockwise to raise or clockwise to lower your refrigerator� The door will close easier if the leveling legs are extended�
7� The following are recommended minimum clearances around the refrigerator for proper air circulation:
Sides: 3/4" (19mm)
Top: 2" (50mm)
Back: 2" (50mm)
Proper air circulation will help your refrigerator work at maximum efficiency�
NOTE: The appliance must be correctly connected to the power supply�
Care should be taken during the handling moving and use of the freezer to avoid dam-
aging the refrigerant tubing or increasing the risk of a leak.
It is important to keep the power cord away from the compressor at the back of the re-
frigerator as during operation, the compressor can reach a high temperature and could
PROTECTION FROM HEAT AND MOISTURE
• Do not install your refrigerator in any location where heavy moisture is present or if the location is not properly insulated� This
refrigerator is not designed to operate in temperature setting below 55° Fahrenheit�
• Location for the refrigerator should be on a hard surface and away from direct sunlight and heat source, e�g�, radiators, baseboard
heaters, cooking appliances, etc�

DOOR ALIGNMENT

1� Remove the top hinge cover�
2� Loosen the top hinge screws using a Phillips head screwdriver�
3� Adjust the door or put a spacer in between and then tighten the screws�
STARTING YOUR NEW REFRIGERATOR
After cleaning your refrigerator thoroughly� Wipe the outside with a soft dry cloth, the interior with a clean moist cloth�
1� Insert the power supply cord into the socket�
2� Turn the thermostat dial to an initial setting of "7" for 15-20 minutes�
NOTE: As the door gets pressed in during shipping, the gasket may have to be reset� This is done to prevent the cool refrigerated
air from escaping� If there is a gap between the door gasket and the cabinet, set the gasket by gently pulling it out of the seal gap�
I CAUTION
I WARNING
cause serious damage to the power cord.
–5–