Unit Diagram; Door Handle Installation; Door Swing Reversal (Optional) - Impecca RA-2106W Manuel De L'utilisateur

UNIT DIAGRAM

1. Freezer Shelf
2. Freezer Temperature Control Panel
3. Adjustable Temperature Control
4. Interior Light
5. Light Switch
6. Full-Width Glass Shelves
7. Clear Crisper
8. Leveling Legs
9. Freezer Door Bins
10. Small Door Bins
11. Can Storage
12. Large Door Bins
Note: Above picture is for reference only. The actual appliance
maybe slightly different.

DOOR HANDLE INSTALLATION

all models)
The refrigerator must be disconnected before attempting the
installation of door handles.
Step 1: Install the two Phillips head screws into the door
holes and turn screws until fully in place.
Step 2: Position the door handle on the screws installed in
Step 1.
Step 3: Install screws at the hole located on the side of the

DOOR SWING REVERSAL (OPTIONAL)

It is advised that you determine if you need to reverse the
door swing and complete this procedure prior to installing
and turning on your refrigerator.
Note: These instructions are for changing the hinges from the
right side to the left side. If you wish to change the hinges back
to the right side, follow these same instructions and reverse all
references to left and right.
CAUTION!! TO AVOID INJURY TO YOURSELF AND/OR
PROPERTY, WE RECOMMEND SOMEONE ASSIST YOU
DURING THE DOOR REVERSAL PROCESS.
• Ensure the appliance is unplugged and empty.
• Adjust the two leveling feet to their highest position.
• Have something solid against which to rest the appliance.
This will be necessary when it comes to taking off the door
• Avoid laying the refrigerator completely flat on its back as
this may damage the cooling system.
TOOLS REQUIRED
• Phillips screwdriver
• Allen key wrench
• Flathead screwdriver
STEP 1: REMOVE THE FREEZER DOOR
Using a flathead screwdriver, gently pry and lift the right top
hinge cover and the left cover plate. Using a Phillip's screw-
driver, unscrew the screws of the right top hinge. Remove the
upper hinge. Raise the freezer door upward to detach.
Le cover plate
(not applicable for
STEP 2: REMOVE THE REFRIGERATOR DOOR
Unscrew the three screws holding the center hinge with a Phil-
–5–
handle and turn screws until completely tight. Install
screw caps as shown in the figure above.
Right top
hinge cover