Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CLEANING & CARING FOR YOUR APPLIANCE
DEFROSTING
The refrigerator defrosts automatically. There is no need to do
defrost manually.
CLEANING THE INTERIOR AND THE EXTERIOR OF THE UNIT
•
Remove all the shelves and the fruit and vegetable bins.
Wipe the inside of the unit with a weak solution of bak-
ing soda (bicarbonate) and then rinse with warm water
using a damp sponge or cloth. Wipe the surfaces com-
pletely dry to prevent buildup of frost before replacing
the shelves and salad bin.
•
Use a damp cloth to clean the exterior, and wipe down
with standard furniture polish. Ensure sure that the door
is closed to avoid the polish getting on the magnetic
door seal or inside the unit.
•
The grille of the condenser at the back of the unit and
the adjacent components can be vacuumed using a soft
brush attachment.
INTERIOR ACCESSORIES
Slide one of the full size glass storage shelves into the lowest set
of guides, above the fruit and vegetable
in this position. To do this, pull the storage shelf forward until it
can be tilted upwards or downwards and removed.
According to your needs, feel free to remove one or more shelves
or drawers from the unit and store them in a safe location for
later re-use.
MAINTENANCE
CHANGING THE LIGHT
Only use a 15W MAX light bulb. Disconnect power to the unit,
remove the plastic cover, unscrew the old light bulb and screw
in the new one in its place.
HANDLING / MOVING YOUR UNIT
Under no circumstances should it be lifted by holding the edges
of the top area of the unit. Hold the unit around its sides or base
when moving it. .
Do not turn the refrigerator upside down, horizontally, or vibrate
the refrigerator. Do not carry at an angle greater than 45°.
NOT USING FOR EXTENDED PERIODS
When the unit is not in use for a long period of time, disconnect
it from the power supply, empty all food and clean the appli-
ance. Prop the door open somewhat with an object to avoid
unpleasant smells and the buildup of mold.
SERVICING
The unit should be serviced by an authorized technician and
with genuine spare parts. Under no circumstances should you
attempt to repair the unit yourself. Repairs carried out by inex-
perienced persons may cause injury or serious malfunction.
REVERSING THE DOOR
Only try to reverse the door hinges if you feel capable of doing
so. Ask someone to assist you during the process. If you are un-
sure if you are able to reverse the hinges, contact a qualified,
authorized technician.
TOOLS REQUIRED (NOT INCLUDED):
BEFORE REVERSING THE DOOR:
containers, and keep it
–2–
•
Phillips screwdriver
•
Flat-head screwdriver
•
Hexagonal spanner
•
Ensure the unit is unplugged and empty.
•
Adjust the two leveling feet to their highest position.
•
To take the door off, you will need to tilt the unit back-
wards. You should rest the unit against something solid
and block the base so that it will not slide out during the
door reversal process.
•
All parts removed must be carefully put aside and re-
used to do the re-installation of the door.
•
Do not lay the unit flat as this may damage the coolant
system.
Door Parts
Parts included with Hinge Kit (packed inside unit)
Top Hinge
Top Hinge Shim
Center Hinge
Center Hinge Shim
Bottom Right Hinge
Right Pin Assembly (2)
Bottom Left Hinge
Left Pin Assembly (2)
Hole Plug (3)
Publicité
Table des Matières
