Dimplex Revillusion RBF24DLX Manuel Du Propriétaire page 20

Maintenance
Reset Temperature Cutoff
Switch
Should the heater overheat, an
automatic cut out will turn the heater
off and it will not come back on without
being reset.
If the fireplace is installed with a
plug, it can be reset by unplugging
the fireplace, waiting 5 minutes and
plugging back in.
If the fireplace is hard-wired, it can
be reset by turning of the electrical
breaker, waiting 5 minutes and turning
the breaker back on.
CAUTION: If you need to con-
tinuously reset the heater, unplug the
unit and call technical support at 1-888-
346-7539.
20
General Maintenance
Inspect the electric fireplace regularly,
depending upon conditions, and at a
minimum yearly intervals. Remove dust
and clean the logs, grate, and base as
required.
WARNING: Disconnect power and
allow heater to cool before attempting
any maintenance or cleaning to reduce
the risk of fire, electric shock, or injury.
CAUTION: Except for installation
and cleaning described in this manual,
an authorized service representative
should perform any other servicing.
Clean Logs and Base
The electric fireplace set should not be
operated with an accumulation of dust
or dirt on or in the fireplace, as this can
cause a build up of heat and eventual
damage.
Dust and vacuum the fireplace as
needed. Use a damp cloth and a mild
detergent to clean painted surfaces
of the electric fireplace. Never use
abrasive cleaners.
www.dimplex.com