Kenwood KDC-PS907 Mode D'emploi page 38

Troubleshooting Guide
PROBLEM
A CD ejects as soon as it is
loaded.
The sound skips on a CD.
A track will not play.
Disc Changer
PROBLEM
The disc changer mode cannot
be selected.
The specified disc does not
play, but another one plays
instead.
The sound skips.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track will not
play.
38
POSSIBLE CAUSE
The CD is upside-down.
The CD is quite dirty.
The CD is scratched or dirty.
Random play has been selected.
POSSIBLE CAUSE
No cable has been connected to the disc changer input
terminal on the unit.
The specified CD is quite dirty.
The CD is upside-down.
The disc is loaded in a different slot from that specified.
The disc is severely scratched.
Something is touching the disc changer.
The CD is scratched or dirty.
The computer chip in the unit is not functioning normally.
Random play or magazine random play has been selected.
SOLUTION
Load the CD with the labeled side up.
Clean the CD, referring to the section on "Cleaning CDs" (see
p. 7).
Clean the CD, referring to the section on "Cleaning CDs" (see
p. 7).
Turn off random play.
SOLUTION
Connect the cable to the disc changer input terminal on the
unit.
Clean the CD.
Load the CD with the labeled side up.
Eject the disc magazine and check the number for the
specified disc.
Try another disc instead.
Remove whatever is touching it.
If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
Press the RESET button on the unit (see p. 6).
Turn off random play or magazine random play.