Table Of Audio Control Setting; Clock Display; Adjusting Time - Kenwood KDC-PS907 Mode D'emploi

Table of Audio Control Setting

Adjustment
Operation of Audio control button
mode
4 button
(Display)
Bass
Bass decreased.
("BAS")
Treble
Treble decreased.
("TRE")
Balance Left channel
("BAL") emphasized.
Fader Rear channel
("FAD") increased.
Non-Fading
Non-fading sound is
Preout Level
reduced.
("NF")
Balanced
Monaural sound is
monaural
reduced.
preout level
("SUB")
NOTE
The balance of the non-fading sound cannot be adjusted.

Clock Display

Display the time.
Switching to Time Display:
Keep pressing the CLK button until the clock is displayed.
You can adjust the time manually. Also, with the automatic
time adjustment function set at ON, you can set the clock time
¢ button
automatically according to time data sent from RBDS stations
(after receiving RBDS signals for several minutes). The factory
default is manual time adjustment.
Bass increased.
Adjusting Time Manually:
Treble increased.
Right channel
emphasized.
Front channel
increased.
Non-fading sound
emphasized.
Turning Automatic Time Adjustment On/Off:
Monaural sound
emphasized.
Adjusting Time Automatically:

Adjusting Time

1
When the time is not displayed, first press the CLK button to
display the time.
2
While holding down the CLK button, press the 4 or ¢
buttons to adjust the time.
The 4 button adjusts the hour and the ¢ button adjusts
the minutes.
NOTE
Do not press the CLK button for two seconds or more, as it will
change to the name preset mode.
Press the 4 or ¢ button quickly to adjust the clock.
1
Press the TUN button repeatedly and switch the display to
"ALL OFF" to enter the standby mode.
2
Press the #1 button for at least three seconds.
Each time you press the button, the automatic time
adjustment function switches on and off.
"SYNC ON" (automatic time adjustment is on.)
"SYNC OFF" (automatic time adjustment is off.)
Tune to a RBDS station and receive the signal for several
minutes.
The clock will adjust automatically to the local time.
NOTE
The clock will not adjust automatically if the RBDS station tuned
to is not transmitting time data. In such a case, try another
RBDS station.
29