Assembly, Controls & Operation - Trotec B 200 Notice D'utilisation

sorb and evaporate water decreases. We recommend
changing the wick at the beginning of every season.
In hard water areas, more frequent replacement may
be necessary to maintain your humidifier's efficiency.
Use only Trotec brand replacement wicks and chem-
icals.
To order parts, wicks and chemicals call +49 2452-
962-200.
The B 200 humidifiers use Model 1045. Only the B
200 evaporative wick guarantees the certified out-
put of your humidifier. Use of wicks other than Trotec
brand will void your warranty as well as the certifi-
cation of output and may reduce the output of your
humidifier.
Dry air is drawn into the humidifier through the back
and moisturised as it passes through the evaporative
wick. It is then fanned out into the room.
m Do NOT position the unit directly in front of a
hot air duct or radiator. Do NOT place on soft
carpet.
1. Water bottle
2. Chassis/Power Pack (motor and fan assembly)
3. Evaporative wick
4. Water reservoir
5. Dry room air intake
6. Moist air output
B - 2
03. Assembly, Controls & Operation
1. Remove the two poly-foam inserts from the top
of the humidifier.
2. Lift off the water bottle cover (left-hand side). Re-
move the water bottle, lift off the chassis/power
pack and then remove the humidifier cabinet from
the carton.
3. Remove the evaporative wick, float assembly
(black rod with white float), and all of the remain-
ing packaging materials from the cabinet. Check
to see that you have all of the following items re-
moved from the boxes accessory kit and cabinet
before discarding the packaging:
• Filler hose
• Caster kit
• Bacterial treatment sample
• Water bottle with cap
• Optional AirCare Filter (purchased separately)
Filling information
4. Your humidifier is equipped with one water bottle.
When both the water bottle and reservoir have
emptied, the humidifier fan will automatically shut
off, but will start again automatically when the wa-
ter bottle and reservoir are refilled.
5. When the bottle is being filled for the first time and
the wick is still dry, it will take approximately 20
minutes to drain the bottle into the reservoir. After
the bottle has emptied, it should be refilled again to
obtain maximum running time.
6. When refilling the bottle and the wick is still wet,
it will take approximately 12 minutes to refill the
reservoir. At this time, you should refill the bottle for
maximum running time.
Casters
7. Turn the emptied cabinet upside down. Insert each
caster stem into the four caster holes on each cor-
ner of the humidifier bottom. The casters should
fit snugly and be inserted until the stem shoulder
reaches the cabinet surface. Do not force.
8. Turn the cabinet right side up.
Operating Manual – Humidifier EN