Remote Control Use - Sharp FP-N40CX Manuel D'utilisation

2
Filter Installation
1
After the True HEPA Filter is removed
from the plastic bag, and place it in
the main unit with the tabs facing up.
(See the diagram to the right.)
Ensure that the filter is installed correctly. Do not
install the filter backwards or the unit will not
operate properly.
2
After removing the Washable Active
Carbon Filter from the plastic bag,
place it on top of the True HEPA Filter
with the bands (2 places) located in
the upper most corners.
3
Next, place the Pre-Filter through the
bands (2 places) located in the cor-
ners of the Washable Active Carbon
Filter.
Insert the tabs of the Pre-Filter into the associ-
ated holes of the main unit.
4
Fill in the usage start date on the Date
Label, which can be found near the
upper edge of the Pre-Filter.
Use the date as a guide for your Filter Replace-
ment schedule.

REMOTE CONTROL USE

• Operate with the remote control facing the main unit (Re-
ceiver).
• The signal range is about 23 feet (front).
• Make sure there are no objects blocking the path of the
signal.
• A beep sound will be heard from the main unit when a
signal is received.
NOTE
• Avoid dropping or damaging the remote control. In addi-
tion, be sure the remote control avoids moisture or place
in direct sunlight or near a electric heater, etc., otherwise a
malfunction may occur.
Ensure the bands are uppermost
Holes in the main unit
Band
Date Label
Receiver
E-11
True HEPA Filter
Tabs
Washable Ac-
tive Carbon Fil-
ter
Pre-Filter
Tab(4 places)
Transmitter