Preparation; Inserting Batteries In The Remote Control; Remote Control Use - Sharp FU-440E Manuel D'utilisation

PREPARATION

INSERTING BATTERIES IN THE REMOTE CONTROL

uster
Light
8
8
ack)

REMOTE CONTROL USE

Operate with the remote control facing the main
•
unit receiver.
• The signal range is about 7m.
• Make sure there are no objects blocking the
path of the signal.
• A beep sound will be heard from the main unit
when a signal is received.
• Avoid dropping or damaging the remote
control, using in a high humidity condition, in
direct sunlight or near a heat source.
d
g
• The battery life is about 1 year.
• The batteries for this remote control are for initial use only . Change the batteries
when necessary.
• Incorrect usage of the batteries may cause battery fluid leakage and/or damage.
Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of the same
type. (Use 2 AA manganese batteries.)
• When not using the unit or remote control for an extended period, remove the
batteries.
• The batteries are for initial use only and may be depleted within 1 year.
NOTE
1
Remove the back cover
Press and slide the back cover to
remove.
2
Insert batteries
Insert batteries with
shown below.
3
Close the back cover
Battery Information
Transmitter
E-5
and as
Receiver