Remote Control Use - Sharp FP-N40CX Manuel D'utilisation

OPERATION
PLASMACLUSTER INDICATOR LIGHT
Plasmacluster ion operation is selected using the remote control.
Blue light
When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode
and the air in the room is impure, the light will activate and the unit will operate in Clean Mode.
Green light
When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster
Ion Mode and the air in the room is clean, this light will activate and the unit will operate in Ion
Control Mode.
Light off
There are no Plasmacluster ions being generated.
• The light can be turned off by using the 'Display ON/OFF Button' on the Remote Control.
(Please turn off the light when not required.)
CLEAN-SIGN LIGHT
The color changes according to the air condition.
Clean (Green) Slightly Impure (Orange)
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the Odor Sensor's reading of the room environ-
ment when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air if the air purifier was just
introduced to the room environment. After a while, however, the base impurity rate will be
adjusted to read room environment correctly.
• Using the Display ON/OFF Button on the remote control can turn off the Indicator light.

REMOTE CONTROL USE

• Operate with the remote control facing the main unit
receiver.
• The signal range is about 23 feet (7m).
• Make sure there are no objects blocking the path of
the signal.
• A beep sound will be heard from the main unit when a
signal is received.
NOTE
• Avoid dropping or damaging the remote control, using
in a high humidity condition, in direct sunlight or near a
heat source.
All manuals and user guides at all-guides.com
Very Impure (Red)
E-13
Receiver
Transmitter