Getting Started With The Transmitter - Carson 501000 Mode D'emploi

Model (8)
Use the pushbutton to scroll through a list of pre-set aircraft
models and select the aircraft model being used. The function
channels are assigned specific functions depending on the air-
craft model selected, as described in the following:
Selection available:
MODEL A: For model planes with ailerons
MODEL V: For model planes with V-tails or for delta-win-
ged aircraft
MODEL H: For helicopters with mixed mechanical func-
tions.
Each function is performed separately by one
servo, having an effect on the model via rod
assemblies and deflections.
MODEL C: For helicopters with a CCPM (collective cyclic
pitch mix) triggering system.
The transmitter's 120° CCPM mixer simulta-
neously controls in proportionate fashion the
three servos staggered by 120° acting directly
upon the swash plate, doing so for roll and
pitch functions.
MODEL C1: Like MODEL C, with reverse direction of
pitch (built-in variant, head servo at the
rear when looking toward the direction of
flight)

Getting started with the transmitter

Inserting the batteries/rechargeable batteries
The power supply of the transmitter requires 8 alkaline batteries
(e.g. Carson item no.: 609000, pack of 4, order 2 x) or accumu-
lators size Mignon (AA). For ecological and also for economical
reasons it is recommended to use rechargeable batteries, since
they can be recharged in the transmitter via a built-in charging
socket.
CARSON 6 Channel Transmitter 501000
Adjustment of length of the remote control levers
The length of the remote control levers can be adjusted by
approx 5 mm. To do so, turn the top part (1) of the remote control
lever counter-clockwise on the threaded control stick until the
desired length is reached. Lock this position by turning the lower
part of the remote control lever (2) against this.
Be sure that the lever is still screwed at least 3-4 mm on the
threaded control stick.
To insert the batteries or rechargeable batteries, proceed
as follows:
● The battery compartment lid (1) is located on the bottom of
the transmitter. Please press the corrugated triangle (2) and
push off the cover.
● Now insert the eight batteries or rechargeable batteries in the
battery compartment. Pay attention to the correct polarity of
the cells. The negative pole (housing) of the battery or re-
chargeable battery must have contact with the spiral spring.
● A corresponding notice (3) is located on the bottom of the
battery compartment.
● Afterwards slide the lid of the battery compartment back on
and let the locking mechanism click into place.
9