Disposal; Troubleshooting - Carson 501000 Mode D'emploi

Disposal

General information
At the end of its service life, dispose of the product according to the relevant statutory regulations.
Batteries and rechargeable batteries
The user is legally obliged (Battery Regulation) to return used batteries and rechargeable batteries. Do not dispose of used
batteries in the domestic waste.
Batteries/storage batteries containing hazardous substances are marked with the following symbols indicating that they are
must not be disposed of in the domestic waste. The markings for hazardous heavy metals are: Cd=cadmium, Hg=mercury,
Pb=lead (name on battery/rechargeable battery, e.g. under the trash icons on the left).
You can return used batteries/rechargeable batteries free of charge to any collecting point in your local community, in our
stores or in any other store where batteries/rechargeable batteries are sold.
Thus, you comply with legal obligations and contribute to environmental protection.

Troubleshooting

Even though the remote control system was designed as a state-of-the-art product, there can still be malfunctions or faults. This is
why we would like to show you how to clear possible malfunctions.
Problem
The transmitter does not
respond.
The servos do not react.
The gas servo does not
respond in the Helicopter
model.
The servos shake.
A servo is humming.
The system has only a low
range.
The transmitter turns off
straight away or after a
short while.
14
Remedy
Check the batteries or rechargeable batteries of the transmitter.
Check the polarity of the batteries or rechargeable batteries.
Check the function switch.
Check the batteries or rechargeable batteries of the receiver.
Test the connecting cable.
Check the BEC function of the control unit
Check the polarity of the servo connector.
Check the markings on the crystals.
Change the crystal to a different channel.
Exchange the receiver for test purposes.
Check the 3D switch. This switch has to be in the OFF position when the trans-
mitter is switched on.
Check the batteries or rechargeable batteries of the transmitter and the model.
Change the crystal to a different channel.
Carefully dry possible dampness in the receiver with a blow-dryer.
Check the receiver antenna for damages and electrical continuity.
Install the receiver antenna in the model differently for test purposes.
Check the batteries or rechargeable batteries of the receiver.
Check that the linkage rods are running smoothly.
Operate the servo without a rudder horn for test purposes.
Pull out the transmitter antenna to its full length.
Check the batteries or rechargeable batteries of the transmitter and the model.
Check the receiver antenna for damages and electrical continuity.
Install the receiver antenna in the model differently for test purposes.
Check the batteries or rechargeable batteries of the transmitter or replace
them.
CARSON 6 Channel Transmitter 501000