GMV GL MRL–MC Manuel D'installation page 16

4.2.5 FRONT WALL (SHELVES AND HEADER)
Lay the compensation panel and stick it to the
entrance upright on the opening door side
Presecure the compensation panel, to the entrance
upright by using hex.-head screws M4, with toothed
washer 4 flat washer 4 and nuts 4, to the floor by
using hex.-head screws M8, with toothed washer 8,
flat washer 8 and nuts 8.
Lay the header between the entrance upright and the
compensatory panel.
Secure the header to the entrance upright and the
compensation panel, using 4 hex.-head screw M 8,
with toothed washer 8 and flat washer 8 inserted in
the proper slot.
WARNING
Verify that the distance H, between the header and the sill is more or equal to 2000 mm, considering the
floor covering thickness.
4.2.6 UPPER ZONE (BASEBOARDS AND ROOF)
Lay ventilated upper baseboard (1) on the side
opposite to the car frame, on panels and column,
sticking to the rear angle and the entrance upright.
Lay the closed upper baseboard (2) on the rear side,
on panel (or mirror), stick it to the rear angles.
Lay ventilated upper baseboard (3) on the side near to
the car frame, on column side panels and "false
column" panel or on the complete wall panel, sticking
to the rear angle and the entrance upright.
Insert with proper fixing supports, on roof sides, the
locking hex.-head screws M8 with multiple washer
(Flat with large support) 8, toothed washers 8
Lay the roof, flat, on the rear angles, uprights and
upper baseboards.
WARNING
Plumb the car and secure it to the car frame
Secure the roof and all presecured parts, by using the hex.-head locking screws M8.
Installation Manual
Car and door operator
Pag. 6 di 8
4
Doc. n° 10991012
Par. n° 10991112
Rev.1.0.6 - 21.12.2005
EN
8