Publicité
STEP 2}
Adjusting the Tracking Force and Anti-Skating
[1] Setting the ANTI-SKATE control to [0]
Rotate
the control
in the direction
indicated
ey the
arrow and align [0] with 'the index line.
Index line
DOWN
Pull down the lever toward you.
Removing the stylus cover
[4] Releasing the arm rest.
Move the arm rest in the direction
of the arrow by hand.
NOTE:
Hold the tonearm with your other
hand since it may move.
Moving the tonearm
Move
the tonearm
to between
the arm
rest and
platter.
[6] Attaining the horizontal balance
(make the tonearm parallel)
As sh
in the figure, rotate the weight part (indicated
as
&
= =
in figure) of the tracking force adjustment
weight in the direction indicated by the arrow and adjust
it so that the tonearm
remains parallel to the cabinet
when it is released.
Anchoring the tonearm to the arm rest
Setting the tracking force scale ring to [0]
Rotate only the tracking force scale ring (indicated as
in figure) of the tracking force adjustment
weight in either of the directions shown by the arrows
and align [0] with the index line.
Tracking force
scale ring
OPERATIONS
BEFORE
USE
NOTE:
®@Hold the weight part with your other hand to prevent
it from rotating with the ring.
@Once
the weight part has been
rotated, attain the
horizontal balance again as under section [6]
[9] Adjusting the tracking force
Rotate the weight (indicated
as
in the
the arrow (the tracking force
scale
ring
also
rotates
to-
gether)
and
align
the
2.0
position
on
the
scale
ring
with the index line.
@One scale unit on the tracking force scale ring is 0.19.
@A tracking force of 3g is applied with every turn of the
weight.
Adjusting the anti-skating
ig e
Rotate
the anti-skating
con-
S
trol
in the direction
of the
arrow and align the 2.0 point
on
the
control
with
the
index line.
Publicité
