Publicité
OPERATIONS BEFORE USE
1. Open the dust cover as far as it will go.
2. Hoid
both
sides of the dust cover
and remove
it
from the cabinet by pulling it up.
NOTE:
Take care not to mark or scratch the dust cover which
you have now removed.
Checking the accessories
The accessories are housed
in the polystyrene cushions
which are used to package the turntable proper.
EP adapter
Tracking
force
ad-
This is used to play
justment weight
records
without
a
This is mounted on-
"middle."
to
the
end
of the
tonearm.
Removing the transit screws
Using a Phillips
head
screwdriver,
rotate
the
transit
screws
(3) in the direction of the arrow in the figure
and remove the platter and the platter cushions.
Phillips head
screwdriver
NOTE:
@The
turntable will not operate unless these screws are
removed.
®Keep
the screws and cushions
in a safe place since
they
are
required
when
transporting
the turntable
from place to place.
Mouting the platter and rubber mat
1. Place the platter over the platter mounting shaft.
2. Place the rubber mat on top of the platter.
shaft
Cr
NOTE:
When
mounting
the platter, take care not to bump it
into
the platter mounting
shaft,
the cabinet and the
tonearm.
Bh
(Before using your turntable, carry out the
instructions in step 1 through step 4.)
weight
Insert the weight over the end of the weight shaft
with the scale side turned in front.
2. Push
it a short way along the shaft and rotate the
weight part (indicated as
in figure) in the
direction
indicated
by the arrow for two or three
turns.
Attaching the tracking force adjustment
1.
Z7>\__—
Tracking force adjustment
A
B®)
[6] Mounting the dust cover
1. Hold both sides of the dust cover and slide the hinges
into the cabinet's hinge holders.
2. Push down until the dust cover goes no further.
Dust cover
/
Hinge]
A
2
Hinge holder
—-23_———CS7 J]
SS
eee
Publicité
