Publicité
6. Install venting, panels, fuel beds, gas supply and so
on as per appliance instruction manual.
LOGS & ROCKS VERSIONS ONLY. Grille cannot be
used with coal fuel bed version. Install the grille panel
inside the appliance:
a. Insert the grille in the firebox by aligning one
of its side edge to the edge of the firebox as
indicated.
Grille inserted
parallel to firebox
edge
b. Raise the grille up to cover the top firebox ports
and hold with one hand.
Note: The port cover strip supplied with the
heater is not required.
c. Place the rear brick wall. It should support the
grille. If not, keep holding it while you place the
side brick walls. Refer to the fireplace installation
manual for more information on installing the
brick walls.
6
7. Install Wall Switch
The wall switch includes a 35 feet cable which connects
to the receiver in the fireplace. The receiver is located
left of the gas valve under the firebox.
Note: You must complete the installation of the wall
switch, connect the battery holder, and test the wall
switch before pairing the remote control handset to the
receiver. See the fireplace's installation instructions for
details on pairing the handset to the receiver.
Caution
DO NOT PUT BATTERIES IN THE REMOTE CONTROL
RECEIVER. DO NOT PUT BATTERIES IN THE
BATTERY HOLDER or DO NOT CONNECT IT to the
receiver BEFORE you connect the wires!
a. Decide where the switch is to be installed in the
wall. Install an electrical outlet box or mud ring
as required (not supplied).
b. Thread the switch wire through an access hole in
the appliance toward the outlet box. The brown
end stays in the engine, the black end goes out
to the wall switch.
Caution
DO NOT RUN the switch wire over top of firebox.
Route wire so it does not contact firebox.
c. If connected, disconnect the battery holder from
the receiver.
d. Pull out the receiver. You can remove the ignition
wire to improve access to the receiver.
e. Take the switch wire and plug the brown
connector into the receiver's connection slot as
indicated (the other slot should already be fitted
with the valve's wire harness connector). See
diagram below.
IMPORTANT: The connection can
only be done one way.
Do not force it or damage the pins
on the receiver box!
Publicité
