Monitor Audio Vector VW-8 Manuel Du Propriétaire page 4

Unpacking
The feet are attached to your product ready to use. The mains power cord is contained separately in the
OR VW-8 AMP PANEL ARTWORK
packaging and should be removed prior to unpacking the product.
ULY 2008
To remove the product from its carton place some protective material on the floor and having removed any
other loose items (mains lead) from the top of the packaging, carefully invert the carton. Also see the icons on
the carton. Gradually pull the carton upwards to expose the subwoofer, which will be presented with its base
uppermost. Remove fixing tape from plastic bag and expose the base/cabinet. The feet are factory fitted to your
product to allow for swift installation and enjoyment of you new purchase.
Amp Panel & Controls for VW-8
1. Power Mode Switch with On-Auto-Off Facility
The Power Mode Switch has three positions: 'On'–'Auto'–'Off'. With the switch in the 'On' position, the
subwoofer is permanently switched on under all conditions. In the 'Auto' position the subwoofer will
automatically switch on when an input signal is received and will remain on until no signal is received for
around 10-15 minutes, the VW-8 will then switch into standby mode until a signal is received once more.
When the switch is in the 'Off' position the subwoofer will not function.
2. Phase
The phase control is used to synchronise the output between the VW-8 and main/satellite speakers. For
All manuals and user guides at all-guides.com
POWER PHASE
5
ON
AUTO
OFF
LEVEL
6
MIN MAX
L
CAUTION:
OFF
115V / 60Hz, FUSE T2 AL / 250V
230V / 50Hz, FUSE T1 AL / 250V
115V
11
230V
BY PASS
ON
0
180
OFF
CROSSOVER
45Hz 150Hz
R
LINE IN
ON
180WATTS
1
2
3
4
7
8
9
10
10a