Operating Instructions - Skil SR211601 Guide D'utilisation

OPERATING INSTRUCTIONS

Attaching Abrasive Discs
WARNING
before attaching or removing abrasive discs.
Place the sander upside down on a flat sur-
face. Remove any dust or debris from the
backing pad. Align the holes of the abrasive
disc with the holes in the backing pad and firm-
ly press the abrasive disc against the backing
pad to ensure a good attachment (Fig. 2).
Turning the Sander On/Off
To turn on the sander, depress the side of the
On/Off switch marked "I". To turn it off, depress
the side of the On/Off switch marked "O"
(Fig. 3).
Variable-Speed Dial
The variable-speed feature on this sander
allows you to match the proper speed to the
material being sanded.
The variable-speed dial is used to adjust the
speed of the tool. Turn the dial to increase or
decrease the speed of the tool. Position "1"
selects the slowest speed; position "6" selects
the fastest speed. Adjust the speed for opti-
mum performance (Fig. 4).
Always disconnect the plug
f r o m t h e p o w e r s o u r c e
Fig. 2
Fig. 3
Fig. 4
11