Publicité
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.
Before taking into operation for the first time, the installation has to be approved by an expert!
OPERATION
After you switch on the power switch, the CLS-41 start running. The lamps light up with the dichroic colours
red, yellow, blue and green.
You can do without a controller as the CLS-41 features a built-in microphone, which provides automatic
sound control. You can adjust the sensitivity of the microphone, the tempo of the chaser and additionally the
three modi with the rotary-controls or the selector switch respectively on the rearpanel.
Master/Slave-Operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the CLS-41 you can find a 9-pole Sub-D socket (OUT) and a 9-pole Sub-D plug (IN),
which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via the link cable. Connect the OUT-
socket with the IN-plug of the next device.
Choose the slave device by adjusting the selector switch on the rearpanel.
Foot-Controller Operation
If you have connected the footswitch to the socket, you can lock the light output and turn it on again.
Buttons 1 – 3 from left to right:
Button 1: Turns the lamp on again and/or begins the next step with the chaser on channel 1.
Button 2: Same function as button 1.
Button 3: Turns the lamps off
All manuals and user guides at all-guides.com
DANGER TO LIFE!
17/35
41907055_V_1_2.DOC
Publicité
