Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION AND SERVICE INSTRUCTIONS
It is important to follow all instructions shipped with this product. This device is to be installed by
a trained electrician who is thoroughly familiar with the National Electric Code/Canadian Electric
Code and will follow the NEC/CEC Guidelines as well as local codes.
The selection of mounting location for the device, its controls and the routing of the wiring is to be
accomplished under the direction of the facilities engineer and the safety engineer. In addition, listed
below are some other important safety instructions and precautions you should follow:
•
Read and understand all instructions before installing or operating this equipment.
•
Disconnect light from the power supply before any installation or maintenance is performed.
•
After installation, test the light system to ensure that it is operating properly.
•
After testing is complete, provide a copy of this instruction sheet to all operating personnel.
•
Establish a procedure to routinely check the light installation for integrity and proper operation.
•
The product nameplate, which may contain cautionary or other information of importance to
maintenance personnel, should not be obscured in any way.
Failure to follow all safety precautions and instructions may result in property damage, serious
injury, or death.
I. INSTALLATION
A. Unpacking
After unpacking the light, examine it for damage that may have occurred in transit. If the equip-
ment has been damaged, do not attempt to install or operate it. File a claim immediately with the
carrier stating the extent of the damage. Carefully check all envelopes, shipping labels, shipping
labels and tags before removing or destroying them.
B. Mounting
The Model AV1 lights are designed for mounting on a flat horizontal surface, a 4" octagonal
electrical box, or on a
using a separately purchased Model LWMB2 (wall mounting bracket) or LCMB2 (corner
mounting bracket) mounting kit. For weatherproof installation, lights must be mounted verti-
cally with the lens facing upwards.
1. Pipe Mounting
a. Attach light to pipe by turning clockwise.
b. Refer to section C for information on making electrical connections.
2. Surface Mounting (See figure 1)
a. Remove the upper housing from the lower housing by removing the three no. 8 screws.
b. Using the gasket as a template, or the dimensions shown in figure 2, scribe three drill
position marks on the mounting surface. Drill a
two outside drill position marks for mounting. Drill or punch
hole at the center drill position mark for wire entry.
c. Remove the appropriate knockouts in the lower housing using a small punch.
d. Locate rubber gasket on mounting surface and set lower housing on top of gasket.
Secure light to the mounting surface using the provided mounting hardware.
e. Refer to section C for information on making electrical connections.
FOR MODEL AV1 AUDIO VISUAL LIGHTS
SAFETY MESSAGE TO INSTALLERS,
USERS AND MAINTENANCE PERSONNEL
1
/
" NPT pipe. Mounting on a vertical surface can be accomplished
2
⁄
3
" (4.8mm) diameter hole at the
16
1
⁄
3
" (19.1mm) diameter
4
Publicité
