STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the NOMAD POWER voltage is inferior to the vehicle voltage, the NOMAD POWER will not operate.
1
SMART
BOOSTER CABLE
Start
2
24 V Manual Activation
Error
3
4
30"
Start
5
Error
7
8
CHARGING MOBILE PHONES
All manuals and user guides at all-guides.com
NOMAD POWER 12V/24V
Choose the right connectors for your battery:
The black connector
vehicles.
Connect the jumper cable to the NOMAD POWER connector.
If the lights «Start» and «Error» flash alternately in green and red, the product is ready.
If the red light only is ON, the internal battery voltage of the NOMAD POWER is too low.
In this event, charge your device.
In 24V mode, if the battery voltage is < 15V, press the manual activation button for 1 s.
using a needle or a paper clip.
Make sure the NOMAD POWER is charged by checking the number of indicators on the
device (minimum of 3 indicators ON (see page 8)).
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp to the (-) of the battery.
If the «Start» light is green and the «Error» light turns off, everything is ok.
The green light stays ON for 30 seconds so the user has 30 seconds to go and start his
vehicle.
(If no action is done during this time, the jumper cable turns itself off and the «Start»
and «Error» indicators will flash again alternately. Unplug and plug back your jumper
cable to the connector device (see step 1).
If only the «Error» indicator is turned ON, starting the vehicle is not possible (see page
10 for more information).
Starting the vehicle: The «Error» indicator flashes red and an alarm beep goes off.
Remove immediately the 2 clamps of the vehicle battery and unplug also the jumper
cable from of the connector.
1 - Connect the cable to the NOMAD POWER USB port 5V 2.1A
2 - Select the appropriate adaptor for your mobile phone or tablet and plug it
in. The NOMAD POWER starts the charge automatically.
for 12V vehicles and the red connector
EN
for 24V
.
9