Publicité
Programming the Chrono mode
a) Setting the current day of the week and time
• Enter into Stand-by mode and press the
3 seconds.
• On the upper part of the display the message Set will be
displayed.
• To set the day and time press the
tom part of the display the message tEd is displayed (see
picture on the right).
• Press the
PROG button to enter the editing mode.
• The blinking arrow indicates the currently selected day:
Pressing the
and
be set.
• Press again the
PROG button to confirm the selected day. After that, the procedure for en-
tering the time starts and the display shows the currently selected time.
• Hours: Use the
pressing the button.
• Minutes: Same procedure as for the hours. Confirm the selected value by pressing the button.
• At the end of the procedure, the thermostat returns into Stand-by mode.
b) Setting the program for the "Chrono" mode
• Enter into Stand-by mode and press the
3 seconds.
• On the upper part of the display the message Set will be
displayed
• To set the day and time press the
tom part of the display the message Prog is displayed (see
picture on the right).
• Press the
PROG button to enter the editing mode.
• Now a time sequence can be defined for each day of the
week. The procedure starts with day 1, and the desired se-
quence can be configured with the
to assign either the Comfort temperature (full bar indication displayed) by pressing the button
or the Night temperature (empty bar) by pressing the button (see picture below).
• Press
PROG to confirm the entered configuration for day 1, and repeat the same procedure
for the remaining 6 days of the week.
All manuals and user guides at all-guides.com
button until the bot-
buttons the desired day can then
and
buttons to set the correct hour and confirm the selected value
button until the bot-
and
button at least
button at least
buttons: for each hour of the day, it is then possible
[ 30 - EN ]
Publicité
