Publicité
Power on / Stand-by
Press the
ON/STAND-BY key to turn on the device or to enter the Stand-by mode.
When activated, the bottom part of the display shows the current time, while the configured op-
erative mode and the temperature are shown in the upper part. When in Stand-by mode current
time, day of the week and the message: Stb are displayed.
NOTE - When the device goes into Stand-by mode it beeps twice for 0.5s.
When the device is activated it beeps once for 1s.
Example in Comfort mode
Comfort and Night modes
Two different levels of temperature can be set:
• Comfort temperature: it is the temperature used for Chrono, Fil-Pilote and Comfort
modes.
• Night temperature: it is the temperature used for the Night and Chrono modes. The desired
temperature can be set pressing the
is 7÷32°C.
IMPORTANT - The temperature of Night mode must be below to the Comfort mode tem-
perature. For this reason the Night mode temperature can be set to a value between 7°C and
the [configured Comfort mode temperature - 0.5°C]. The temperature of Comfort mode can
be configured in the whole [Night temperature + 0.5°C] ÷ 32°C range.
Operating the device
Press the
PROG button to select the desired operative mode. An icon on the display indicates
the selected operating mode, according to the following table:
Fil-Pilote
Comfort
Comfort mode
The Comfort stably maintains the room temperature to a selected value.To set this operative-
mode:
• Press the
PROG button until the display shows the
• Set the desired temperature through
ture stops blinking.
All manuals and user guides at all-guides.com
and
Night
Example in Stand-by mode
buttons. The range of configurable temperature
Antifreeze
Comfort icon.
and
buttons and wait until the displayed tempera-
[ 28 - EN ]
Timer 2h
Chrono
Publicité
