Publicité
˜ How to exchange the pin inside the slider
(Fig. F, G, H)
Take out the slider 11 , open the bottom cover 13 with the spare pin 12
inside (Fig . G) .
You will need the pliers (not included) to carefully remove the old pin from the
slider (Fig . H) .
Insert the spare pin 12 carefully into the rotating slider 11 by again using the pliers
(not included) . The new pin is installed .
˜ Cleaning and care
Clean the product on the outside only with a soft, wet and clean cloth .
Rinse the product under the running water if necessary . Dry thoroughly after rinse .
˜ Disposal
The packaging is made entirely of recyclable materials, which you may dispose of at
local recycling facilities .
Observe the marking of the packaging materials for waste separation,
which are marked with abbreviations (a) and numbers (b) with following
meaning: 1 - 7: plastics / 20 - 22: paper and fibreboard / 80 - 98:
composite materials .
GB/IE/NI
11
Publicité
