Télécharger Imprimer la page

Scosche Industries EGMT249F Manuel D'installation page 9

Publicité

2003-07 Hummer H1
RADIO REMOVAL:
1. Remove (4) Screws securing radio/dash
bezel & remove.
2. Remove (3) 7mm hex screws holding radio,
unplug and remove.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
2003-07 Hummer H2
RADIO REMOVAL:
1. Open center console storage and extract
4 screws securing hinged lid.
2. Remove Torx lock nut holding Shift lever
(Nut is facing forward) and Slide shift
lever off.
3. Use a panel removal tool to carefully
pop up cup
holder/gear indicator plate.
4. Extract (2) 7mm hex screws at bottom of center
dash bezel (revealed in previous step #3).
5. Extract (2) 7mm hex screws from center dash bezel (near each vent).
6. Carefully pry out on center dash bezel to unsnap, unplug and remove.
7. Extract (3) 7mm hex screws holding radio, unplug and remove.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
1995-00 Oldsmobile Alero
RADIO REMOVAL:
1. Unsnap shifter panel and leave it loose.
2. Using a panel removal tool remove radio
trim bezel (there are a total of six snaps)
unplug and remove.
3. Extract (3) 9/32" screws holding radio,
unplug and remove.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
1995-00 Oldsmobile Aurora
RADIO REMOVAL:
1. Carefully unsnap dash bezel and remove.
2. Extract (3) 7mm screws securing radio,
unplug connectors, antenna lead and
remove radio.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
USE SHADED BRACKETS
SUPPORTS OMBRÉS
USE SHADED BRACKETS
USE SHADED BRACKETS
9
UTILISEZ LES
UTILISEZ LES
SUPPORTS OMBRÉS
USE SHADED BRACKETS
UTILISEZ LES
SUPPORTS OMBRÉS
UTILISEZ LES
SUPPORTS OMBRÉS

Publicité

loading