Publicité
2004-UP Chevrolet Colorado
2004-UP GMC Canyon
RADIO REMOVAL:
1. Unsnap dash bezel, lift away,
disconnect and remove.
2. Unscrew (3) Hex bolts securing radio,
lift away, unplug and remove.
NOTE: FOR THIS APPLICATION, USE SPACERS AND THE SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS AND
DISCARD. (SEE ILLUSTRATION).
REMARQUE: POUR CETTE APPLICATION, UTILISEZ LES ENTRETOISES ET LES SUPPORTS OMBRÉS. COUPEZ ET JETEZ LES-
SUPPORTS RESTANTS. (VOIR L'ILLUSTRATION)
2001-07 Chevrolet Express
2001-07 GMC Savana
RADIO REMOVAL:
1. Carefully pry out on dash bezel to release,
unplug and remove.
2. Remove three (3) 7mm hex screws holding
radio, unplug and remove.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
2000-05 Chevrolet Impala
RADIO REMOVAL:
1. Extract (2) 9/32" hex screws from
above instrument panel.
2. Remove fuse panel cover and extract
(1) 9/32" hex screw from behind.
3. Remove passenger side fuse cover and
extract (1) 9/32" screw from behind.
4. Drop underdash covering using panel
removal tool and extract (2) 9/32"
screws from behind.
5. Remove (1) 9/32" screw from left side trim,
tilt wheel down, and pull away dash bezel, disconnect and remove.
6. Remove (3) 9/32" screws securing the radio, disconnect and remove from dash.
NOTE: FOR THIS APPLICATION, USE SPACERS AND THE SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
(SEE ILLUSTRATION).
REMARQUE: POUR CETTE APPLICATION, UTILISEZ LES ENTRETOISES ET LES SUPPORTS OMBRÉS. COUPEZ ET JETEZ LES
SUPPORTS RESTANTS. (VOIR L'ILLUSTRATION)
2001-03 Chevrolet Malibu
2004 Chevrolet Classic
RADIO REMOVAL:
1. Use a small fl at blade or pick to remove
ignition switch collar.
2. Using panel removal tool, pry out dash bezel,
disconnect and remove.
3. Remove three (3) 7mm screws securing radio,
disconnect and remove.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
USE SHADED BRACKETS
UTILISEZ LES
SUPPORTS OMBRÉS
USE SHADED SPACERS
UTILISEZ LES ENTRETOISE OMBRÉS
USE SHADED BRACKETS
USE SHADED BRACKETS
UTILISEZ LES
SUPPORTS OMBRÉS
USE SHADED SPACERS
UTILISEZ LES ENTRETOISE OMBRÉS
USE SHADED BRACKETS
SUPPORTS OMBRÉS
6
UTILISEZ LES
SUPPORTS OMBRÉS
UTILISEZ LES
Publicité
