Publicité
2003-05 Chevrolet Blazer
2002-04 Chevrolet S-10 Pickup
RADIO REMOVAL:
1. Turn ignition ON and shift vehicle into
fi rst if an automatic.
2. Extract (1) 9/32" screw from above
gauge cluster.
3. Extract (5) 9/32" screws from unerdash
pane; and remove.
4. Extract (2) 9/32" screws from bottom of
dash bezel, and carefully pry out bezel.
CAUTION: WHEN YOU GO TO PULL BEZEL
OVER HAZARD SWITCH BE VERY CAREFUL
NOT TO BREAK SWITCH. DISCONNECT
AND REMOVE BEZEL.
5. Extract (3) 9/32" screws securing radio, disconnect, and remove.
NOTE: FOR THIS APPLICATION, USE SPACERS AND THE SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
(SEE ILLUSTRATION).
REMARQUE: POUR CETTE APPLICATION, UTILISEZ LES ENTRETOISES ET LES SUPPORTS OMBRÉS. COUPEZ ET JETEZ LES
SUPPORTS RESTANTS. (VOIR L'ILLUSTRATION)
2000-05 Chevrolet Venture
2000-04 Oldsmobile Silhouette
2000-05 Pontiac Montana
RADIO REMOVAL:
1. Remove ashtray and extract (2) Phillips
head screws from behind.
2. Unsnap perimeter of radio trim bezel,
lift away and remove. Extract (3)
Phillips head screws securing radio,
lift away, disconnect and remove.
NOTE: FOR THIS APPLICATION, USE SPACERS AND THE SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
(SEE ILLUSTRATION).
REMARQUE: POUR CETTE APPLICATION, UTILISEZ LES ENTRETOISES ET LES SUPPORTS OMBRÉS. COUPEZ ET JETEZ LES
SUPPORTS RESTANTS. (VOIR L'ILLUSTRATION)
2002-UP GMC Envoy
2004-06 Buick Rainier
2003-08 Isuzu Ascender
RADIO REMOVAL:
NOTE: The factory radio provision is for a
DIN and half sized radio.
1. Open center console lid and extract (2)
Phillips screws from front of console, lift
out rubber pads and extract (4) more
Phillips screws from under. Remove console insert.
2. Extract (2) 9/32" screws from console cavity.
3. Remove rubber pad from front cup holder and extract (1) 9/32" screw from under.
4. Extract (4) Philips screws from sides of carpeted panel directly under radio and climate
controls, pull it down and out of the way.
5. Pull center console back and down to get to (2)
Philips screws on bottom of radio bezel. Pry bezel
out from top to bottom, disconnect, and remove.
6. Extract (3) 9/32" screws securing radio.
USE SHADED BRACKETS
UTILISEZ LES
SUPPORTS OMBRÉS
USE SHADED SPACERS
UTILISEZ LES ENTRETOISE OMBRÉS
USE SHADED BRACKETS
UTILISEZ LES
SUPPORTS OMBRÉS
USE SHADED SPACERS
UTILISEZ LES ENTRETOISE OMBRÉS
USE SHADED BRACKETS
SUPPORTS OMBRÉS
USE SHADED SPACERS
UTILISEZ LES ENTRETOISE OMBRÉS
NOTE: FOR THIS APPLICATION, USE SPACERS AND THE
SHADED BRACKETS. CUT OFF THE REMAINING BRACKETS
AND DISCARD. (SEE ILLUSTRATION).
REMARQUE: POUR CETTE APPLICATION, UTILISEZ LES
ENTRETOISES ET LES SUPPORTS OMBRÉS. COUPEZ ET
JETEZ LESSUPPORTS RESTANTS. (VOIR L'ILLUSTRATION)
8
UTILISEZ LES
Publicité
