Publicité
1995-96 Buick Regal
1995-99 Oldsmobile Cutlass /
Cutlass Supreme
RADIO REMOVAL:
1. Tilt steering column down to lowest position.
2. Unsnap dash bezel and remove.
3. Extract (3) 7mm screws securing radio,
unplug connectors, antenna lead and remove radio.
PLEASE NOTE: Back of dash cavity may need modifi cation.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
1996-98 Buick Riviera
RADIO REMOVAL:
1. Gently pull outward on Left and Right
windshield pillar panels to release (2) snap clips
and extract each one.
2. Unsnap side dash panels and remove (1)
7mm screw from behind each.
3. Extract (6) plastic push-pin fasteners from under
front edge of upper dash pad. Pull outward
to remove the bottom panel of the upper dash pad.
4. Extract (5) 7mm screws securing upper dash pad, lift up and outward to remove pad.
5. Carefully pull outward on dash/instrument bezel to release clips, unplug
and remove bezel.
6. Extract (3) 7mm screws from climate control module, unplug and remove module.
7. Extract (4) 7mm screws securing radio, unplug connectors, antenna lead,
and remove radio.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
1995-96 Buick Roadmaster
RADIO REMOVAL:
1. Remove side dash panels by carefully pulling
outward on them to release fastening clips.
2. Carefully pull out on underdash panel below
steering column to release fastening clips,
and remove panel.
3. Carefully pull outward on lower panel at right
of glove box to release fastening clips, and remove panel.
4. Extract (2) 7mm screws above instrument cluster.
5. Make sure the parking brake is on, then insert the key and turn to the "on" position.
6. Put the vehicle into fi rst or low gear, and tilt the steering column adjustment all the way
down and pull outward on the complete instrument panel around gauges and along top
of glovebox. Panel clips will release and dash panel can be removed.
7. Extract (3) 7mm screws holding radio, unplug connector, antenna cable
and remove radio.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
USE SHADED BRACKETS
USE SHADED BRACKETS
4
UTILISEZ LES
SUPPORTS OMBRÉS
USE SHADED BRACKETS
UTILISEZ LES
SUPPORTS OMBRÉS
UTILISEZ LES
SUPPORTS OMBRÉS
Publicité
