Publicité
This premium installation kit is for 1994-UP General Motors vehicles with oversize radio/M3000,
2002 Toyota Matrix, Pontiac Vibe and 2000-UP Saturn vehicles. Included are all the parts you
need to mount your car stereo, cassette, or CD player into your vehicle's dash. Refer to the indi-
vidual instruction in this manual to remove your vehicle's factory radio and assemble the kit.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTAL-
LATION TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHM
METER OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE
CAN CAUSE DAMAGE TO THE VEHICLE'S COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID
ALL FACTORY AIRBAG WIRING - AIRBAGS CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS
INJURY OR DEATH.
NOTES:
• See your vehicle's instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo/cassette player for proper wiring
and mounting instructions.
For Factory Wiring Codes go to:
FLATFACE DIN/DETACHABLE FACEPLATE/PULLOUT (DIN-E) RADIOS
Slide the metal sleeve (metal shroud) into the panel's radio opening and bend all available
mounting tabs outward (see inset). Slide the radio into the mounting
sleeve once it has been fastened to the kit panel until the radio locks into place.
NOTE: The mounting sleeve must be removed from the radio
fi rst! Your radio may be snapped into its sleeve. Slide the
mounting sleeve (metal shroud) off the radio towards the back.
SHAFT TAB NOTE:
SNAP SHAFT MOUNTING TABS
NOT INCLUDED. IF REQUIRED
FOR YOUR STEREO INSTALLATION,
CALL 800-821-36945 X3 FOR
IMMEDIATE SHIPMENT
ATTACHING SATURN
BRACKETS
1. Line up the matching bracket
to its matching side.
2. Align the snaps with the
mounting snap location.
3. Apply pressure to allow snap
to lock in mounting
snap location.
INTRODUCTION / PRELIMINARY
FACTORY WIRING CODES
ASSEMBLING THE KIT
ATTACHING THE POCKET:
Align the pocket to the snaps of
kit panel. Snap the pocket into
place on the back of kit panel.
www.e2audio.com
RADIO'S
MOUNTING
SLEEVE
ISO
MOUNT
RADIO
2
5283
MOUNTING
KIT PANEL
BEND TABS
OUTWARD
5440
POCKET
Publicité
