Publicité
1997-05 Buick Century
RADIO REMOVAL:
1. Extract (1) screw from bottom lower dash panel
at right of glove box.
2. Open glove box and pop out small lower dash
panel along the right side.
3. Carefully pop out fuse box cover at right side of dash
and extract (1) screw from the dash bezel at the
right of the air vent.
4. Extract (2) screws at the bottom of the lower ashtray/lighter dash section pop out and remove.
5. Extract (1) screw from the right driver's side lower dash panel and one panel popper from the left side.
6. Carefully pop out the driver's side lower dash panel and remove.
7. Put the vehicle into fi rst or low gear, and tilt the steering column adjustment all the way down and pull
outward on the complete dash panel to unsnap, unplug, and remove panel.
8. Extract (3) 7mm screws holding radio, unplug connector, antenna cable and remove radio.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
1995-99 Buick Le Sabre
1995-05 Buick Park Avenue
RADIO REMOVAL:
1. Pop out small narrow trim panel around trunk/fuel
door buttons and extract on screw at left.
2. Carefully pop out small narrow trim panel around A/C
heater controls and bottom of passenger airbag.
Extract (1) screw at far right and (1) screw above glove box.
3. Using a panel removal tool or small fl at-blade screwdriver
pop out all (4) dash vents and remove (1) screw behind each vent.
4. Make sure the parking brake is on, then insert the key and turn to the "on" position.
5. Put the vehicle into fi rst or low gear, and tilt the steering column adjustment all the way down and pull
outward on the complete dash panel.
6. Extract (3) 7mm screws holding radio, unplug connector, antenna cable and remove radio.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
1997-04 Buick Regal
RADIO REMOVAL:
1. Unsnap gear selector trim bezel, unplug and remove the
bezel. Extract (2) 10mm bolts from metal console bracket.
2. Open armrest storage, lift up rubber mat and extract
(2) 10mmbolts from underneath.
3. Extract (2) 10mm bolts from the front sides of the console,
which are concealed up under the dash.
4. Slide shifter back into low gear, push down on spring-loaded
shifter trim and pull complete center console to rear of the vehicle, allowing
the center lower dash section (attached) to unsnap from the dash.
5. Extract (1) screw from bottom lower dash panel at right of glove box.
6. Open glove box and pop out small lower dash panel along the right side.
7. Carefully pop out fuse box cover at right side of dash and extract
(1) screw from the dash bezel at the right of the air vent.
8. Extract (1) screw from the lower right of driver's side lower dash panel and one panel popper
from the left side.
9. Carefully pop out the driver's side lower dash panel and remove.
10. Extract (3) 7mm screws holding radio, unplug connector, antenna cable and remove radio.
NOTE: USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
REMARQUE: UTILISEZ LES SUPPORTS OMBRÉS ET LES TROUS SPÉCIFIÉS. COUPEZ ET JETEZ LES SUPPORTS RESTANTS.
USE SHADED BRACKETS
USE SHADED BRACKETS
USE SHADED BRACKETS
3
UTILISEZ LES
SUPPORTS OMBRÉS
UTILISEZ LES
SUPPORTS OMBRÉS
UTILISEZ LES
SUPPORTS OMBRÉS
Publicité
