Auto Restart Function; Indoor Controller Board - Mitsubishi Electric SVZ-KP12NA Manuel D'installation

NOTE
Operation is not possible for about 30 seconds after cancellation of function selection.
(Correct operation)
For description of each LED (LED1, 2, 3) provided on the indoor controller, refer
to the following table.
LED 1 (power for microcomputer)
LED 2 (power for remote controller)
LED 3 (communication between indoor and
outdoor units)

15.4. AUTO RESTART FUNCTION

Indoor controller board

This model is equipped with the AUTO RESTART FUNCTION.
When the indoor unit is controlled with the remote controller, the operation mode, set temperature, and the
fan speed are memorized by the indoor controller board.
The auto restart function sets to work the moment the power has restored after power failure, then, the unit
will restart automatically.
Set the AUTO RESTART FUNCTION using the remote controller. (Mode no.01)
Specifications are subject to change without notice.
SVZ-KP12,18, 24, 30, 36NA
Indicates whether control power is supplied. Make sure that this LED is always lit.
Indicates whether power is supplied to the remote controller. This LED lights only in the case of the indoor unit which is
connected to the outdoor unit refrigerant address "0".
Indicates state of communication between the indoor and outdoor units. Make sure that this LED is always blinking.
53 © 2020 Mitsubishi Electric US, Inc.