Publicité
g) All containers of solvents used in spraying, in
accordance with the applicable legislation
currently in force. Use only containers which are
metallic and electrical conductors. Do not place
these containers on non-conductor surfaces such
as paper or cardboard which interrupt the
continuity of the grounding of the element.
h)To maintain grounding continuity during
cleaning or decompression, always keep a
Moving parts are liable to injure or amputate fingers or other parts of the body. Keep
away from moving parts at start-up or when using a pump. Before checking or
servicing the pump, follow the compression procedure given on page 15 to avoid
Maximum operating pressure
Dimensions
Weight
Maximum temperature
Product inlet
Product outlet
Parts in contact with fluid
metallic part of the spray gun (hand protector)
firmly pressed to the side of the container which
is placed on the floor, and then operate the gun
3.3.2. Safety during spraying
Reduce the risk of product injection, static
electricity sparks or splashes, by following the
spraying procedure described below.
NOTE
accidentally starting up the pump.
4. TECHNICAL DATA
300 Bar
175 x 65 millimetres
817 grams
72 degrees
1/4" Gas
1/4" Gas
Stainless steel, Nylon, Aluminium,
Viton, Tungsten Carbide.
- 17 -
Publicité
