M
I
8
G
I
N
O
L
P
ENGLISH
HOW TO ASSEMBLE
Assemble completely and charge batteries for 14-16
hours before using.
H
CAUTION: Use only Eureka model JOD-S-100020A5-C-3 charger.
Have a screwdriver available for assembly (not included).
Attach Handle Grip
Step 1: Locate the 2-part bolt
Step 2: Align the handle grip and handle tube holes and
secure with the 2-part bolt
Note: The single hole in the handle tube faces
Attach Handle
Step 1: Use your thumb to pull back on the lock button
Step 2: Push handle
Step 3: Release lock button
it locks into place.
Secure Wall Bracket on Wall
Have a 1/4 inch drill available for assembly (not included).
Cleaner hangs in bracket with the nozzle end down. Mount
on a wall in close proximity to an electrical outlet where
there are not dangerous objects hidden beneath the wall
surface like electrical wires, pipes, etc. Leave 14 inches
above the floor for clearance.
Step 1: Hold bracket
screws. Make sure the wall bracket is positioned
vertically, with the charger socket at the bottom.
Step 2: Use a 1/4 inch drill for drilling holes for the plastic
anchors
Step 3: Insert the anchors
into both holes.
Step 4: Tighten the screws
Step 5: Place cleaner, with the nozzle pointed down, on
the wall bracket
Step 6: Plug the charger
Note: This charger has been designed to use as either
a wall mounted charger or to sit on a counter
or shelf
next to an electrical outlet. Take the battery
out of the cleaner and put in the counter bracket
. The charge light
I
AA
charging stand, and
the battery is charging (Fig. 4).
(CONTINUED)
(Fig. 1)
in the assembly package.
H
AA
H
. Tighten the bolt
AA
forward in relation to the handle grip.
(Fig. 2)
G
into top of cleaner.
AA
AA
M
and rotate handle
AA
AA
I
against wall to mark location for
AA
AA
N
.
AA
AA
AA
N
and drive the screws
AA
O
to secure the bracket
AA
.
I
I
AA
L
into an electrical outlet.
AA
P
. To use on a counter or shelf, locate
AA
J
indicates power on to
AA
K
will indicate that the
M
.
AA
AA
G
until
AA
AA
(Fig. 3)
O
I
.
I
C
AA