Parts List; How To Assemble - Eureka 2940-2969 Série Guide Du Propriétaire

Table des Matières

Publicité

G
H
D
C
A
B
F
D
FIG. 2
C
G
6
FIG. 4
E
F
FIG. 1
J
E
FIG. 3
A
FIG. 5
ENGLISH

PARTS LIST

(FIG. 1)
A
Wand and crevice wand (pull apart)
B
Dusting brush
C
Hose
D
Vacuum cleaner body
E
Electrical cord
F
Handle
G
Self-cleaning duster
H
Turbo tool (some models only)
I
Screws located in the accessory package

HOW TO ASSEMBLE

CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts. Make sure ON/OFF switch is in the OFF
position before plugging in.
Step 1: Slide the handle
D
body
as shown (FIG. 2).
Step 2: Place the two screws (supplied) into the holes at back of the unit
and tighten with a screwdriver (FIG. 2).
Step 3: Pull the electrical cord
push down into retainer. This will keep the cord out of the way
the next time you vacuum (FIG. 3).
Step 4: Wind the cord around the two cord hooks
vacuum (FIG. 3).
Step 5: Secure plug to the cord to prevent unwinding (FIG. 3).
Step 6: Place the hose
and over the hose hook as shown (FIG. 4).
Step 7: Secure the bottom of the self cleaning duster
retainer. Firmly push the end of the hose into the top of the self
cleaning duster (FIG. 4).
Step 8: Store the wands
hose (FIG. 5).
Step 9: Store the dusting brush
K
K
B
F
into the grooves at the top of the vacuum
E
up to the cord retainer
K
C
on the back of the vacuum, wrapping it up
A
on the side of the vacuum in front of the
B
on its holder (FIG. 6).
FIG. 6
J
and firmly
on the back of the
G
to the hose

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2970-2999 série

Table des Matières