●
L
16
ENGLISH
Upholstery and Stair Cleaning
Step 4: Place the Upholstery Nozzle at the top of the cleaning area.
Step 5: Pull up and hold the solution release trigger and pull the nozzle
Step 6: Release the trigger at the end of the stroke.
Step 7: Lift nozzle and start again at the top. Apply one to three spraying
Note: As the nozzle moves over the surface, the cleaning solution
Step 8: Move the nozzle over the surface several more times without
Step 9: Adjust shampoo control to rinse and repeat steps 5-8 for a clean
Step 10: Press release button on top of hose to release attachment.
Step 11: After using attachment make sure hose inlet cover
Step 12: Clean upholstery brush attachment after use. Press attachment
HOW TO MAINTAIN
Before storing the extractor for long periods of time, it is a good
FIG. 9
idea to set the shampoo control on rinse and push the spray button
for 10 seconds. This flushes the shampoo residue from the pump.
Place cleaner on a surface where water can easily be cleaned up. If
any attachments have been used clear hose line in same way.
Empty the Recovery Tank
See page 12 for instructions.
Clean Suction Cover
CAUTION: Turn off the power switch and unplug the electrical cord
●
M
Step 1: Slide the suction cover release tabs
Step 2: Remove the suction cover and clean the area of dirt and lint.
Step 3: Replace the suction cover by sliding the tabs on top of the
●
L
FIG. 10
backward at a moderate pace for no more than five seconds to
avoid over soaking.
strokes. Avoid over-soaking the area.
sprays onto the surface. At the same time the nozzle picks up
the dirty water and places it in the recovery tank.
engaging the trigger. This removes excess water and helps the
surface dry faster.
water rinse.
closed.
release to remove from hose, pull suction cover open (Fig. 9),
rinse under warm running water. Replace on hose or store in
caddy.
before cleaning.
●
M
suction cover
(Fig. 10).
suction cover into the top slots on the hood.
(continued)
●
H
is fully
●
L
up on each side of the