Meter-Feet Changeover („M" / „Ft"); Shooting Format Adjustment (S Zoom) - Metz MECABLITZ 50 AF-1 Mode D'emploi

9.7 Meter-feet changeover („m" / „ft")
The maximum flash range indicated by the flash unit's display can either be
shown in metres or feet.
Setting procedure
• Press the button combination „Select" until the only the distance dimension
„m" or „ft" flashes.
• Apply the setting desired with the buttons + and —.
– When „m" is displayed, the distance display is in metres.
– When „ft" is displayed, the distance display is in feet.
The setting takes effect immediately.
After about five seconds, the display stops flashing and the setting is saved
automatically.
106

9.8 Shooting format adjustment (S Zoom)

Certain types of digital cameras allow the display for the position of the main
reflector to be adjusted to chip-format (dimensions of the recording module)
using the Zoom Size function („S Zoom").
Setting procedure
• actuate the shutter release in order to transfer data from the flash unit to the
camera.
• repeatedly press button combination
„Select" until „Zoom" appears in the
display and „S" flashes.
• the required settings can be applied using
the + and — buttons.
– when „S On" is displayed the
Zoom–Size function is activated.
– when „S Off" is displayed the Zoom–Size function
is deactivated.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and
the setting is saved automatically.
„S" is shown in the display following activation of the
Zoom-Size function.
☞ The Zoom size function cannot be set with cameras which do not support
shooting format adjustment!
S
OFF
S
On
On
S