Publicité
PEDAL ASSEMBLY
Attach the pedals to the cranks using an allen
Unscrew the brake lever clamps (Torx T25) and
8.1
9.1
wrench. Apply some grease to the threads, if
remove the attachments of the brake and shift
there are washers make sure to use them!
cables
Please note that there's a right and a left
pedal.
The non-drive side pedal has reverse thread-
Mount the brake levers on your handlebar with
8.2
9.3
ing and is therefore tightened counterclock-
the brake lever clamps. Make sure the clamp
wise.
and the break fit neatly into another and to
leave no gap (zero gap).
1 4 y t
All manuals and user guides at all-guides.com
BRAKE SWAP
Swap the brake levers to have the front brake
9.2
on your right and the rear brake on your left
side.
Make sure the levers are correctly aligned and
9.4
tighten them with a torque wrench.
INSERTION DEPTH OF THE SEAT POST
The minimum insertion depth of the seat post
10.1
is 10 cm. If you insert less, the frame can break
under load. Please also notice the maximum
insertion depth and do not insert the seat
post deeper into the seat tube, otherwise it
may cause damage to the frame in case of
heavy impact.
We added a rubber seal to your ToolBox. Slide
Once you have properly adjusted your seat
10.3
10.2
it onto the seat post right above the clamp
post height, tighten the seat post clamp with a
torque of 6 – 7 Nm.
and tighten the bolt to keep the dirt out.
MAXIMUM
INSERTION DEPTH
OF THE SEAT POST
TUES 27 Carbon ( MK3)
S – L:
12 cm
XL – XXL: 14 cm
TUES 27 Aluminum (MK3)
S – XXL: 13 cm
TUES 29 Carbon (MK3)
Regular:
13 cm
Long:
13 cm
X-Long:
16 cm
y t 1 5
Publicité
