Publicité
HANDLEBAR ASSEMBLY
RACEFACE ATLAS / CHESTER DIRECT MOUNT
Remove the stem bolts from the upper fork
Put the screws in the stem then place the
2.2.1
2.2.2
crown (Allen key 5 mm)
handlebar and the stem on the upper fork
crown.
Torque the bolts exactly to the specifications
2.2.4
of the manufacturer of the stem and / or han-
dlebar (refer to the black box on the right of
this page). Make sure the gaps in the clamp
are even and that the handlebar is centered
correctly – the adjustment graphics will help
you with this.
0 8 y t
All manuals and user guides at all-guides.com
Mount the stem on the upper fork crown
2.2.3
(5 mm Allen key). Tighten the screws in an X
pattern. Do it step by step with just one turn
per screw at a time.This is the only way to
achieve an even clamping of the bolts.
REAR DERAILLEUR ASSEMBLY
Make sure the bike is standing safely on the
Turn the rear axle stand on its side. Carefully
3.1
3.2
rear axle stand.
cut the cable tie using a wire cutter and re-
move the bubble wrap and the foam transport
protection from the chainstay.
Tighten the rear derailleur screw using the
3.4
torque wrench. Make sure that the rear de-
railleur stop sits at the derailleur hanger stop.
Hold the derailleur with your second hand to
avoid a twisting of the derailleur and a gap.
Mount the rear derailleur on the derailleur
3.3
hanger (Allen key 5 mm). Please make sure
the bolt is perpendicular to the hanger to avoid
damaging the thread.
Please follow the
torque specifications of
the manufacturers
y t 0 9
Publicité
