Publicité
English
Mounting the Loop Handle
A barrier bar is supplied with the
machine. Attach the barrier bar to the
loop handle.
2
1
Insert square nuts (1) in the barrier
N
bar (2) – the holes must line up
8
All manuals and user guides at all-guides.com
4
5
6
1
Insert the clamp (3) in the loop
N
handle (4) and position them
together on the shaft (5)
Position clamp (6)
N
Position barrier bar (2) – note
N
position!
Line up the holes
N
Insert bolts (7) in the holes – and
N
screw them into the barrier bar as
far as possible
2
3
7
A
8
4
9
Fit the loop handle (4) at a distance
N
of (A) approx. 20 cm (8 in) forward
of the control handle (8)
Orient the loop handle
N
Tighten the bolts – lock the nuts if
N
necessary
The sleeve (9) is present depending on
the country and must be located
between the loop handle and control
handle.
Always leave the barrier bar attached.
KM 55 R, KM 55 RC
Publicité
