Publicité
11. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
The operator and/or user is solely responsible to property damage and personal injury.
IV- GETTING STARTED
Before any intervention on product, ensure that product is disconnected from
its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
Content:
-
1 Reciprocating saw
-
1 wood/plastic blade
-
1 metal blade
-
1 hex key
4.2- Installing and removing the cutting blade (Fig.2)
4.2.1- Installing a cutting blade
Note1: Use only a clean work tool. Before insertion into the
clamp, lubricate the shaft of the blade lightly with machine
grease.
1. Rotate the quick release blade clamp (3) a half turn
anticlockwise.
2. Insert a blade into the blade holder (3) as inside as possible,
then release the quick-release blade clamp, make sure it is
securely fastened
Warning! Before plugging in power cord, always pull on the
blade to make sure it is securely locked in the clamp. Failure to
do so may result in serious injury.
4.2.2- Removing a cutting blade
1. Rotate the quick release blade clamp (3) a half turn anticlockwise
2. Remove the blade from the blade holder.
3. Clean the cutting blade and rub it over with a small amount of machine grease.
Fig. 2
Page 18 of 33
Publicité
