Lamello Tanga Delta H Mode D'emploi page 16

English
Application Tanga Delta H
The Lamello Tanga Delta H is ideal for the window
replacement. Ideal for cutting out the old window frames
by cutting into the wood frame.
It can be use for the following tasks:
– Removing of old window frames without taking off
the window sills
– Cutting wood materials such as soid wood, plywood,
chipboard, fibre board as well as various plastic materials
Instruction of use
Connect a high performance vacuum cleaner; clean filters frequently!
1. Use eye and ear protection
2. Set the depth adjuster to the correct blade diameter (turn to 180 or 200 mm)
3. Adjust the desired cutting depth by shifting the stop sleeve (stepless)
4. Set machine onto the work-piece. Apply the machine securety.
5. Start the machine, immerse and push forward in the direction of rotation with light pressure (Careful: Do not
overload the engine!)
Without rabbet stop
Changing of tool
1. Disconnect machine from power supply
2. Open quick-locking mechanism
3. Remove bottom plate by pulling forward
4. Press spindle stop, un-tighten the 4 countersunk
screws with a screw driver; change blade (consider
direction of rotation!); re-tighten the 4 screws
5. Attache square bottom plate
6. Adjust the depth adjuster to correct blade diameter
(turn to 180 or 200 mm)
7. Let the machine run free at maximum speed for at
least 30 seconds to test correct mounting of the tool
With rabbet stop
– Shortening doors and cutting of wood covers
– Cutting of expansion gaps (gap width 7mm)
– Making cuts into walls and ceiling for ventilation
openings etc.
– Roofing apertures or cutting to length of roof battens
The use of the machine is limited to the specified
materials. All instructions regarding use and maintenance
are to be strictly complied to.
Please note
– The machine is supplied ready for use.
– The saw emerges from the machine housing only
during actual operation.
– Overload protection: This machine is equipped with a
power overload protection.
– For cutting through nails and screws, the following
special carbide cut-off blade with cutting angle zero is
available: carbide cut-off blade 24 teeth Art. no. 132321
These blades are only suitable for plunge cutting.