Publicité
EN
Use
CAUTION!
■
Never insert the blade attachments into the motor unit without a shaker / soup mixing
container.
■
Danger of damage due to insuffi cient cooling! Never place the motor unit on a
soft surface. The ventilation openings on the side and bottom of the motor unit must
not be covered.
■
Do not overfi ll the device! Make sure that the maximum fi ll level (MAX marking in
the shaker / soup mixing container) is not exceeded!
■
Danger of damage from incorrect use of the accessories! The device should only
be used if it has been completely and correctly assembled!
■
Danger of damage from unforeseen events! Do not leave the device unattended
when it is in use.
■
Make sure that the device remains stable during operation. Always hold the motor
unit fi rmly with one hand.
■
The device may not be transported while it is switched on.
■
Read the "Using Accessories Correctly" chapter for details of the correct way to use
and assemble the accessories.
• The device has an automatic switch-off function. If no settings are made within
the space of 3 minutes in stand-by mode, the device switches off automatically.
To carry on working, switch the device back on by pressing the Start / Stopp
(start/stop) button (C).
• The display (A) and the operating lamp (7) are only switched on if a shaker/
soup mixing container (3, 11, 12) has been fi tted on the motor unit correctly.
• A programme can be changed at any time during operation by pressing the
Funktion (function) button (B) or be stopped by pressing the Start / Stopp
(start/stop) button (C).
Processing Cold Ingredients / Without Heating
CAUTION!
■
Danger of burns! Never fi ll the small or large shaker with hot food or liquids! The
contents must not be hotter than 50°C.
When processing frozen fruit or vegetables, always pour a little liquid into the
shaker (11, 12) as well.
For all programmes, apart from Erhitzen (heating):
1. Place the motor unit (5) on a work surface:
– This must be dry, clean, fl at and not heatable.
– The suction feet (8) must stick to it fi rmly.
– Make sure that there is a suffi cient gap from the edge of the work surface so that
the device does not fall off during operation.
All manuals and user guides at all-guides.com
24
Publicité
