Publicité
INSTALLATION
PLUMBING REQUIREMENTS
Installation must comply with all applicable plumbing codes.
Place the water supply and drain in an adjacent cabinet.
NOTE
The dishwasher must be connected to a
cold water inlet hose.
WARNING
A hose that attaches to a tap can burst if
installed on the same water line as the
dishwasher. If your sink has one, it is
recommended to disconnect the hose and
plug the hole.
We recommend fitting a filter to your water inlet supply in
order to prevent damage to your machine due to
contamination (sand, rust, etc.) from indoor plumbing. This
will also help prevent yellowing and deposit formation after
washing.
The edges of the opening must be smooth and round.
The water supply may be connected to the dishwasher with
either:
•
A metal braided hose
•
Copper tubing
Use the new water inlet hose supplied with your machine,
do not use an old machine's hose.
Run water through the new hose before connecting. This
precaution is needed to avoid the risk of the water inlet to
be blocked and damage the appliance.
Connect the cold water supply hose to a threaded 3/4"
connector and make sure that it is fastened tightly in place.
The pressure supplied by the tap should be a minimum of
0.04 MPa and a maximum of 1 MPa. If the pressure
exceeds 1 MPa, a pressure relief valve must be fitted
between the connection.
After the connections are made, turn the tap on fully and
check for water leaks.
A safety supply hose is available with some models. The
system ensures its intervention by blocking the flow of
water in the event of a break in the supply hose and when
the air space between the supply hose itself and the outer
corrugated hose is full of water.
To connect a safety supply hose:
1) Pull the safety supply hoses out from storage
compartment located at rear of dishwasher.
14
2) Tighten the screws of the safety supply hose to the
faucet with thread 3/4".
3) Turn the water fully on before starting the dishwasher.
To disconnect a safety supply hose:
1) Turn off the water.
2) Unscrew the safety supply hose from the faucet.
Connect the water drain hose directly to water drain pipe or
to the sink outlet spigot. This connection should be
minimum 50 cm and maximum 100 cm from floor that
dishwasher is placed.
The free end of the hose must not be immersed in water to
avoid the back flow of it.
WARNING
If the connection to the drain pipe is
positioned higher than 1000 mm, excess
water may remain in the drain hose. It will
be necessary to drain excess water from
the hose into a bowl or suitable container
that is held outside and lower than the sink.
A
B
A. max 100 cm
B. min 50 cm
C. min 4 cm
Purge the water supply prior to final connection to the unit.
This will remove any debris that may be present in the
tubing when installing the new water supply. Connect the
braided tubing from the unit to the household water supply
with the fitting provided.
Check all water supply fittings for leaks.
NOTE
Items will not wash properly if an extension
drain hose longer than 4 m is used.
C
Fig. 8
Publicité
