Publicité
USE
OPERATION
Setting a wash cycle
1) Press the button for the desired wash cycle. Cycle
number will appear on the display.
2) Press Start/Pause and close the door. The cycle will start
right after.
3) The display shows total time of the selected cycle and
the remaining time during operation.
Changing a cycle
To change the wash cycle while the dishwasher is running,
open the door and press the Program button for 3 seconds
to select a new cycle, then press the Start/Pause button.
After closing the door, the newly selected cycle will resume
the course of the old one.
NOTE
A program can only be changed if it has
been running only for a short period of time,
otherwise the detergent may have already
been released or the wash water with
detergent has already been drained. If this
is the case, the dishwasher needs to be
reset and the detergent dispenser must be
refilled
Pausing a cycle
A forgotten dish can be added any time before the
detergent dispenser opens. If this is the case, follow the
instructions below:
1) Open the door a little to stop the washing cycle
2) After the spray arms stop spinning, open the door
completely
3) Add forgotten dishes
4) Close the door and dishwasher will resume its operation
after 10 seconds
WARNING
It is dangerous to open the door mid-cycle,
as hot steam may escape from the
dishwasher. Always be cautious and open
the door ever so slightly first, then fully only
after a few minutes.
Switching the dishwasher off
When the selected program is completed, the buzzer will
also sound 5 times. You can then switch your machine off
using the Power On/Off button. Disconnect the plug and
turn off the water tap.
NOTE
If the power is cut off during the drying
process, the program will terminate. Your
machine will be ready for a new program
selection.
Auto open door
After completing a wash cycle the door opens automatically
to achieve better drying results.
NOTE
The dishwasher door must not be blocked
when set to open automatically. this can
disrupt door lock functionality.
37
Publicité
